LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1429 (Seat Belt System) >> Repair Instructions >> Seat Belt Retractor Replacement - No. 1 Center Rear (TrailBlazer EXT, Envoy XL, Envoy XUV) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the 3 screws securing the inboard rear seat back cushion latch cover.
    Fig 1: Identifying Seat Belt Side Buckle & Retaining Nut
    GM828140Courtesy of GENERAL MOTORS CORP.
    2. Fig 2: View Of Rear Center Seat Belt Anchor Nut
    GM828141Courtesy of GENERAL MOTORS CORP.
  2. Remove the rear seat belt anchor nut (2) securing the seat belt (1) to the seat frame.
  3. Pull the seat back cover and pad up to expose the seat belt bracket bolts. Refer to Seat Back Cover and Pad Replacement - Rear No. 1 (TrailBlazer, Envoy, Bravada) or Seat Back Cover and Pad Replacement - Rear No. 1 (TrailBlazer EXT, Envoy XL, Envoy XUV) .
    4. Fig 3: Removing/Installing Seat Belt Bracket
    GM828222Courtesy of GENERAL MOTORS CORP.
  4. Remove the 2 bolts (2) securing the seat belt bracket (1) to the seat back frame.
    5. Fig 4: Removing/Installing Retractor Assembly
    GM828220Courtesy of GENERAL MOTORS CORP.
  5. Remove the nut (1) securing the retractor assembly (2) to the seat back frame.
  6. Remove the retractor assembly.
scientia non olet · About LEMON Manuals