Installation Procedure
WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
- Position the rear seat belt retractor assembly to the vehicle.
- Install the bolts which retain the rear seat belt retractor assembly to the body.
Tighten: Tighten the rear seat belt retractor bolts to 70 N.m (52 lb ft).
- Install the rear quarter lower trim, left or right side. Refer to Trim Panel Replacement - Rear Quarter - Left (TrailBlazer, Envoy, Bravada) or Trim Panel Replacement - Rear Quarter - Left (TrailBlazer EXT, Envoy XL) , or to Trim Panel Replacement - Rear Quarter - Right (TrailBlazer, Envoy, Bravada) or Trim Panel Replacement - Rear Quarter - Right (TrailBlazer EXT, Envoy XL) in Interior Trim.
- Install the rear seat belt floor anchor bolt. Ensure that the seat belt webbing is not twisted.
Tighten: Tighten the rear seat belt floor anchor bolt to 70 N.m (52 lb ft).
- Install the anchor bolt cover.
- Install the rear quarter upper trim, left or right side. Refer to Trim Panel Replacement - Rear Quarter Upper (TrailBlazer, Envoy, Bravada) in Interior Trim.
- Install the rear seat belt upper guide with the bolt. Ensure that the seat belt webbing is not twisted.
Tighten: Tighten the rear seat belt upper guide bolt to 70 N.m (52 lb ft).
NOTE:
Refer to Fastener Notice in Cautions and Notices.