Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Rear Seat Belt Retractor Assembly

Courtesy of GENERAL MOTORS CORP.

Position the rear seat belt retractor assembly to the vehicle.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the bolts which retain the rear seat belt retractor assembly to the body.
Tighten: Tighten the rear seat belt retractor bolts to 70 N.m (52 lb ft).
Install the upper body lock pillar trim panel. Refer to Trim Panel Replacement - Body Lock Pillar Upper (Envoy XUV) in Interior Trim.

Fig 2: Removing/Installing Rear Seat Belt Floor Anchor Bolt

Courtesy of GENERAL MOTORS CORP.

Install the rear seat belt floor anchor bolt. Ensure that the seat belt webbing is not twisted.
Tighten: Tighten the rear seat belt floor anchor bolt to 70 N.m (52 lb ft).

Fig 3: Removing/Installing Upper Rear Seat Belt Guide Bolt

Courtesy of GENERAL MOTORS CORP.

Install the rear seat belt upper guide with the bolt. Ensure that the seat belt webbing is not twisted.
Tighten: Tighten the rear seat belt upper guide bolt to 70 N.m (52 lb ft).