LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1429 (Seat Belt System) >> Repair Instructions >> Seat Belt Replacement - Front >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Seat Belt Retractor Bracket
    GM757367Courtesy of GENERAL MOTORS CORP.
  1. Position the seat belt retractor bracket on the seat back frame.
    2. Fig 2: Removing/Installing Seat Belt Retractor Bracket Bolt
    GM757363Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the seat belt retractor bracket bolt (1) to the bracket and seat back frame.

    Tighten:  Tighten the seat belt retractor bracket bolt to 55 N.m (40 lb ft).

  3. Position the seat belt retractor assembly onto the seat back frame.

    Install the push pin (2) on the seat back retractor to the seat back frame.

  4. Install the lower seat belt retractor bolt.

    Tighten:  Tighten the lower seat belt retractor bolt to 55 N.m (40 lb ft).

    5. Fig 3: Removing/Installing Seat Belt At Retractor Bracket
    GM757364Courtesy of GENERAL MOTORS CORP.
  5. Install the seat belt into the retractor bracket by guiding the seat belt through the slot in the bracket.
  6. Install the seat back panel to the seat back frame. Refer to Seat Back Panel Replacement - Front in Seats.
  7. Install the seat back pad and cover. Refer to Seat Back Cover and Pad Replacement - Front in Seats.
  8. Slide the front seat back seat belt bezel onto the seat belt.
    9. Fig 4: Removing/Installing Seat Belt Bezel Retaining Screw
    GM752860Courtesy of GENERAL MOTORS CORP.
  9. Install the seat belt bezel to the retractor bracket with the screw.

    Tighten:  Tighten the front seat back seat belt bezel screw to 6 N.m (53 lb in).

    10. Fig 5: Removing/Installing Seat Belt Anchor Nut
    GM752863Courtesy of GENERAL MOTORS CORP.
  10. Install the seat belt anchor to the seat adjuster assembly with the nut. Ensure that the seat belt webbing is not twisted.

    Tighten:  Tighten the seat back anchor nut to 52 N.m (38 lb ft).

  11. Install the seat trim panel. Refer to Seat Cushion Outer Trim Panel Replacement in Seats.
  12. Install the seat switch bezel. Refer to Seat Switch Bezel Replacement in Seats.
scientia non olet · About LEMON Manuals