LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1429 (Seat Belt System) >> Repair Instructions >> Seat Belt Buckle Replacement - Center Rear (TrailBlazer, Envoy, Bravada) >> Installation procedure

Installation procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the seat belt buckle/anchor plate to the vehicle.
    2. Fig 1: Removing/Installing Rear Seat Back
    GM753692Courtesy of GENERAL MOTORS CORP.
  2. Install the clip(s) that retain the seat belt buckle/anchor plate to the latch bracket.
  3. Adjust the left seat back to a cargo position.
  4. Adjust the seat filler panel in order to access the center rear seat back bracket/seat belt buckle anchor plate.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
  5. Install the center seat back/seat belt buckle mounting nut.

    Tighten:  Tighten the center rear seat back mounting nut to 45 N.m (33 lb ft).

  6. Return the seat to an upright position.
scientia non olet · About LEMON Manuals