LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1429 (Seat Belt System) >> Repair Instructions >> Child Restraint Tether Anchor Replacement - Rear No. 1 (TrailBlazer, Envoy, Bravada) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Child Restraint Tether Anchors
    GM744907Courtesy of GENERAL MOTORS CORP.
  1. Install the child restraint tether anchor to the floor with the pivot point of the anchor ring indexed toward the front of the vehicle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the bolt that retains the child restraint tether anchor to the floor panel.

    Tighten:  Tighten the child restraint tether anchor bolt to 35 N.m (26 lb ft).

  3. Close the liftgate.
scientia non olet · About LEMON Manuals