LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1429 (Seat Belt System) >> Repair Instructions >> Child Restraint Tether Anchor Replacement - Rear No. 1 (TrailBlazer EXT, Envoy XL) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Refer to Fastener Notice in Cautions and Notices.
  1. Install the child tether anchor (2) to the seat cushion frame with the bolt (1).

    Tighten:  Tighten the child restraint tether anchor bolt to 35 N.m (26 lb ft).

    Fig 1: Removing/Installing Child Tether Anchor To Seat Cushion Frame
    GM828233Courtesy of GENERAL MOTORS CORP.
  2. Install the trim panel to the seat cushion. Refer to Seat Cushion Trim Panel Replacement - Rear No.1 (TrailBlazer EXT, Envoy XL, Envoy XUV) .
  3. Install the seat in the vehicle. Refer to Seat Replacement - Rear No. 1 (TrailBlazer EXT, Envoy XL, Envoy XUV) .
scientia non olet · About LEMON Manuals