LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1427 (Theft Deterrent System & Anti-Theft System) >> Diagnostic Information and Procedures >> DTC B3031 >> Test Description

Test Description

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

The number below refers to the step number on the diagnostic table.

  1. 2:  To set this code, a key with a working transponder was read by the theft deterrent control module. For that key to operate the vehicle a 10 Minute or 30 Minute Re-Learn Procedure must be performed.
DTC B3031

Step Action Yes No
Schematic Reference:  Theft Deterrent System Schematics  
Connector End View Reference:  Theft Deterrent System Connector End Views  
1 Did you perform the Theft Deterrent Diagnostic System Check? Go to Step 2  Go to Diagnostic System Check - Theft Deterrent 
IMPORTANT: If a 10 Minute or 30 Minute Re-Learn Procedure is performed, all keys not learned at that time will be erased and will not be recognized. Perform the Adding Keys procedure on all keys or instruct the customer how to perform the Adding Keys procedure. Refer to Adding Keys  .
Perform the Programming Theft Deterrent System Components procedure. Refer to Programming Theft Deterrent System Components  .Is the procedure complete?
Go to Step 3  -
3
  1. Use the scan tool in order to clear the DTCs.
  2. Operate the vehicle within the Conditions for Running the DTC as specified in the supporting text.
Does the DTC reset?
Go to Step 2  System OK