Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Remove the 12-volt power supply or cigar lighter fuse.

Fig 1: Removing Accessory Power Receptacle (1 Of 2)

Courtesy of GENERAL MOTORS CORP.

Remove the socket by placing one side of the "T" portion of the tool J 42059 into the socket and into the square window tab.
Position the opposite "T" portion of the tool into the opposing square window tab.

Fig 2: Removing Accessory Power Receptacle (2 Of 2)

Courtesy of GENERAL MOTORS CORP.

Pull the socket straight out of the retaining ring.
Remove the tool from the socket.

Fig 3: Disconnecting Accessory Power Receptacle Electrical Connector

Courtesy of GENERAL MOTORS CORP.

Disconnect the electrical connector from the socket.

Fig 4: Removing Accessory Power Receptacle Retaining Ring

Courtesy of GENERAL MOTORS CORP.

Using your finger, remove the socket retaining ring by pulling the retaining ring out of the mounting hole.