LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1422 (Body Rear End) >> Repair Instructions >> Window Replacement - Endgate >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lower the endgate window approximately halfway down.
  2. Swing the endgate open.
  3. Remove the endgate window outer sealing strip. Refer to Sealing Strip Replacement - Endgate Window - Outer .
  4. Remove the endgate trim panel. Refer to Trim Panel Replacement - Endgate (Envoy XUV) .
  5. Remove the inner reinforcement panel. Refer to Reinforcement Inner Panel Replacement - Endgate .
    6. Fig 1: Removing Endgate Window
    GM902609Courtesy of GENERAL MOTORS CORP.
  6. Disconnect the electrical connectors from the defogger grid on the window.
  7. Remove the bolts (2) retaining the endgate window clips (1) to the regulator carrier plates.
  8. Remove the window from the endgate.
scientia non olet · About LEMON Manuals