LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1422 (Body Rear End) >> Repair Instructions >> Window Regulator Replacement - Endgate >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Swing the endgate open.
  2. Remove the regulator bolt access plugs (3).
    Fig 1: Removing Regulator Bolt Access Plugs
    GM902601Courtesy of GENERAL MOTORS CORP.
  3. Remove the endgate trim panel. Refer to Trim Panel Replacement - Endgate (Envoy XUV) .
  4. Remove the endgate inner panel reinforcement. Refer to Reinforcement Inner Panel Replacement - Endgate .
  5. Remove the endgate window. Refer to Window Replacement - Endgate .
  6. Remove the bolt (3) retaining the regulator to the endgate.
  7. Loosen the nuts (1) retaining the regulator rails to the endgate.
  8. Remove the regulator by sliding the regulator side rails up and out of the keyhole slots (2) in the gate.
    9. Fig 2: Removing Endgate Window Regulator
    GM902615Courtesy of GENERAL MOTORS CORP.
  9. Disconnect the electrical connector from the window regulator.
  10. Remove the regulator assembly from the endgate out the access hole.
scientia non olet · About LEMON Manuals