LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1422 (Body Rear End) >> Repair Instructions >> Window Adjustment - Endgate Cross Car >> Adjustment Procedure

Adjustment Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lower the endgate window approximately halfway down.
  2. Swing the endgate open.
  3. Remove the endgate trim panel. Refer to Trim Panel Replacement - Endgate (Envoy XUV) .
  4. Loosen the window attachment clip bolts (1).
    Fig 1: Identifying Window Attachment Clip Bolts & Endgate Window Adjustment Cam Screw
    GM902602Courtesy of GENERAL MOTORS CORP.
  5. Adjust the cross car position of the endgate window by turning the adjustment cam screw (2).
  6. Turn the adjustment cam screws to center the window to the opening with the rear roof applique.
    7. NOTE: Refer to Fastener Notice in Cautions and Notices.
  7. Tighten the window attachment clip bolts (1).

    Tighten:  Tighten the window attachment clip bolts to 10 N.m (89 lb in).

  8. Install the endgate window sealing strip to the endgate flanges. Refer to Sealing Strip Replacement - Endgate Window - Outer .
  9. Install the endgate trim panel. Refer to Trim Panel Replacement - Endgate (Envoy XUV) .
scientia non olet · About LEMON Manuals