LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1422 (Body Rear End) >> Repair Instructions >> Wheelhouse Panel Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Wheelhouse Panel
    GM752095Courtesy of GENERAL MOTORS CORP.
  1. Install the wheelhouse panel to the vehicle.
  2. Install the 4 push-pins retaining the panel to the wheelhouse.
    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Install the 2 screws that retain the wheelhouse panel to the rear fascia.

    Tighten:  Tighten the 2 screw to 2 N.m (18 lb in).

  4. Install the bolt that retains the wheelhouse panel to the rocker panel molding.

    Tighten:  Tighten the bolt to 7 N.m (62 lb in).

scientia non olet · About LEMON Manuals