LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1422 (Body Rear End) >> Repair Instructions >> Wedge Replacement - Endgate - Body Side >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Body Side Endgate Wedge
    GM1236627Courtesy of GENERAL MOTORS CORP.
  1. Align the tab (1) on the endgate body side wedge to the slot in the body.
  2. Press the body side wedge assembly onto the body.
  3. Install the screw retaining the body side wedge to the body.

    Tighten:  Tighten the screw only until the wedge does not rock, but will still slide fore and aft.

  4. Slide the wedge (2) fully rearward.
  5. Close the endgate to set the wedge to the correct position.
    6. NOTE: Refer to Fastener Notice in Cautions and Notices.
  6. Open the endgate and secure the body side wedge to the body.

    Tighten:  Tighten the body side wedge screw to 10 N.m (89 lb in).

scientia non olet · About LEMON Manuals