LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1422 (Body Rear End) >> Repair Instructions >> Weatherstrip Replacement - Midgate >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Open the midgate.
  2. Lift up and hold the midgate sliding hinge panel.
  3. Slide the retaining clips (1) up to the midgate sliding hinge panel in place.
    Fig 1: Identifying Midgate Sliding Hinge Panel Retaining Clips
    GM1236624Courtesy of GENERAL MOTORS CORP.
  4. Remove the pushpins (1) retaining the midgate weatherstrip mold to the body.
  5. Remove the midgate weatherstrip from the pinch-weld flange and window channel.
    Fig 2: Removing Midgate Weatherstrip
    GM1204237Courtesy of GENERAL MOTORS CORP.
  6. Remove the midgate weatherstrip from the vehicle.
scientia non olet · About LEMON Manuals