LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1422 (Body Rear End) >> Repair Instructions >> Weatherstrip Replacement - Liftgate Window >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the liftgate window weatherstrip, starting at the top center of the liftgate window opening position the liftgate window weatherstrip to the pinch-weld flange and working down the right and left sides towards the bottom center, being careful not to stretch the liftgate window weatherstrip while installing it.
    Fig 1: Installing Liftgate Window Weatherstrip
    GM721405Courtesy of GENERAL MOTORS CORP.
  2. Install the butt joint seam at the center of the bottom pinch-weld flange.
  3. Use a rubber mallet to ensure full engagement of the liftgate window weatherstrip to the pinch-weld flange.
  4. Spooning of the liftgate window weatherstrip may be required to complete the installation of the liftgate window weatherstrip.
  5. Close the liftgate window.
scientia non olet · About LEMON Manuals