LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1422 (Body Rear End) >> Repair Instructions >> Weatherstrip Replacement - Endgate >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the endgate weatherstrip upper molds to the roof module with the integral push-pins (2).
    Fig 1: Installing Endgate Weatherstrip
    GM1229210Courtesy of GENERAL MOTORS CORP.
  2. Install the weatherstrip onto the bulb flange of the moveable roof. Ensure the roof module weatherstrip cups over the endgate weatherstrip.
  3. Install the endgate weatherstrip lower molds (1) to the vehicle with the integral push-pins.
  4. Install the weatherstrip to the endgate opening flange.
  5. Close the moveable roof.
  6. Close the endgate.
scientia non olet · About LEMON Manuals