LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1422 (Body Rear End) >> Repair Instructions >> Trim Panel Replacement - Liftgate (TrailBlazer, Envoy, Bravada) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Trim Panel To Liftgate
    GM721369Courtesy of GENERAL MOTORS CORP.
  1. Install the trim panel to the liftgate.
  2. Ensure that the trim panel retainers are fully seated.
  3. Install the pullstrap to the trim panel.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Install the screw that retains the pullstrap to the trim panel.

    Tighten:  Tighten the pullstrap screw to 4 N.m (35 lb in).

  5. Close the liftgate.
  6. Open the liftgate window.
  7. Install the push-pin retainer.
    Fig 2: Installing Push-Pin Retainer Into Trim Panel
    GM769633Courtesy of GENERAL MOTORS CORP.
  8. Close the liftgate window.
scientia non olet · About LEMON Manuals