LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1422 (Body Rear End) >> Repair Instructions >> Trim Panel Replacement - Endgate (Envoy XUV) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position the endgate panel onto the endgate.
    Fig 1: Positioning Endgate Panel Onto The Endgate
    GM1236745Courtesy of GENERAL MOTORS CORP.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the 6 endgate panel screws retaining the panel to the endgate.

    Tighten:  Tighten the endgate panel screws to 4 N.m (35 lb in).

scientia non olet · About LEMON Manuals