LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1422 (Body Rear End) >> Repair Instructions >> Switch Replacement - Endgate Window Interior Emergency >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Partially remove the left rear quarter trim panel to access the switch retaining tabs located behind the panel. Refer to Trim Panel Replacement - Rear Quarter - Left (TrailBlazer, Envoy, Bravada) or Trim Panel Replacement - Rear Quarter - Left (TrailBlazer EXT, Envoy XL) .
  2. Fig 1: Disconnecting Endgate Window Interior Emergency Switch Connector
    GM1200035Courtesy of GENERAL MOTORS CORP.
  3. Disconnect the electrical connector to the switch.
  4. Release the tabs (1) retaining the switch to the panel.
  5. Fig 2: Removing Endgate Window Interior Emergency Switch
    GM1200032Courtesy of GENERAL MOTORS CORP.
  6. Remove the switch from the vehicle.