LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1422 (Body Rear End) >> Repair Instructions >> Striker Replacement - Midgate >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Midgate Latch Striker
    GM1204235Courtesy of GENERAL MOTORS CORP.
  1. Install the midgate latch striker and shim (if equipped) to the vehicle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the screws retaining the striker to the body.

    Tighten:  Tighten the screws retaining the midgate latch striker to 10 N.m (89 lb in).

scientia non olet · About LEMON Manuals