LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1422 (Body Rear End) >> Repair Instructions >> Striker Replacement - Endgate Upper Lock - Left >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Endgate Upper Lock Striker - Left
    GM902630Courtesy of GENERAL MOTORS CORP.
  1. Install the upper striker (1) and shim, if equipped, to the vehicle.
  2. Install the nuts (4) retaining the upper striker to the vehicle.

    Tighten:  Tighten the nuts only until the striker will not rock up and down, but can slide up and down.

    3. NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Close the endgate so that it is fully latched.

    Tighten:  Tighten the upper striker nuts to 25 N.m (18 lb ft).

    4. Fig 2: Installing Striker Access Hole Sealing Strip
    GM1284422Courtesy of GENERAL MOTORS CORP.
  4. Install the sealing strip (1) covering the striker access hole.
  5. Install the left tail lamp assembly. Refer to Tail Lamp Replacement in Lighting Systems.
scientia non olet · About LEMON Manuals