LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1422 (Body Rear End) >> Repair Instructions >> Striker Adjustment - Liftgate Window >> Adjustment Procedure

Adjustment Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Liftgate Window Striker Shims
    GM856363Courtesy of GENERAL MOTORS CORP.
  1. Inspect the liftgate window for proper fit to the liftgate window weatherstrip.
    • Open and close the liftgate window.
    • If the liftgate window is hard to close, additional striker shims will need to be added.
    • If the liftgate window does not seal tightly against the weatherstrip, striker shims will need to be removed.
  2. Open the liftgate window.
  3. Loosen the nuts retaining the liftgate striker to the liftgate window.
    4. NOTE: Refer to Fastener Notice in Cautions and Notices.
  4. Remove or add shims as determined above.

    Tighten:  Tighten the liftgate window striker nuts to 6 N.m (53 lb in).

  5. Inspect the liftgate window for proper fit, readjust if necessary.
  6. Close the liftgate window.
scientia non olet · About LEMON Manuals