LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1422 (Body Rear End) >> Repair Instructions >> Side Reveal Molding Replacement - Liftgate >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Side Reveal Molding
    GM721401Courtesy of GENERAL MOTORS CORP.
  1. Remove the adhesive liner from the reveal molding, if applicable.
  2. Position the reveal molding to the body.
  3. Align the retaining clips on the reveal molding with the recesses in the body.
  4. Starting at the bottom of the reveal molding, seat the molding to the body. Ensure that the retaining clips are fully seated.
  5. Close the liftgate.
scientia non olet · About LEMON Manuals