LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1422 (Body Rear End) >> Repair Instructions >> Sealing Strip Replacement - Midgate Window Outer >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Align the tab on the midgate window sealing strip to the notch in the midgate flange.
    Fig 1: Installing Midgate Window Sealing Strip - Outer
    GM986352Courtesy of GENERAL MOTORS CORP.
  2. Install the window sealing strip to the midgate flanges, pressing down until the seal is fully seated.
  3. Remove the pins (2) or allen wrenches from the midgate hinges (1) supporting the midgate.
    Fig 2: Removing Midgate Support Pins
    GM1236621Courtesy of GENERAL MOTORS CORP.
  4. Close the midgate, ensuring the latches are fully engaged.
  5. Close the midgate window. Ensure the window sealing strip remains fully seated and not binding against the midgate window.
scientia non olet · About LEMON Manuals