LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1422 (Body Rear End) >> Repair Instructions >> Opening the Endgate When There Is an Electrical Failure >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lower the endgate window out of the roof rear header seal.
  2. Remove the endgate trim panel. Refer to Trim Panel Replacement - Endgate (Envoy XUV) .
  3. Remove the endgate inner reinforcement panel. Refer to Reinforcement Inner Panel Replacement - Endgate .
    4. Fig 1: Locating Manual Release Lever
    GM1239377Courtesy of GENERAL MOTORS CORP.
  4. Locate the manual release lever (1), located on the upper and lower left latches (2).
  5. Slide the manual release levers (1) upward to swing open the endgate.
  6. Diagnose and repair the endgate latches.
scientia non olet · About LEMON Manuals