LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1422 (Body Rear End) >> Repair Instructions >> Midgate Panel Replacement - Outer >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the midgate assembly from the vehicle. Refer to Midgate Replacement .
  2. Place the midgate assembly on a clean surface.
  3. Remove the midgate inner panel. Refer to Midgate Panel Replacement - Inner .
  4. Remove the midgate window sealing strip. Refer to Sealing Strip Replacement - Midgate Window Outer .
  5. Remove the midgate window. Refer to Window Replacement - Midgate .
  6. Remove the midgate window regulator. Refer to Window Regulator Replacement - Midgate .
  7. Remove the midgate window run channels. Refer to Window Channel Replacement - Midgate .
  8. Remove the midgate sliding hinge filler panel. Refer to Hinge Filler Panel Replacement - Midgate Sliding .
    9. Fig 1: Removing Midgate Outer Panel From Midgate
    GM1033832Courtesy of GENERAL MOTORS CORP.
  9. Remove the nuts retaining the midgate outer panel to the midgate structure.
  10. Remove the midgate outer panel from the midgate.
scientia non olet · About LEMON Manuals