LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1422 (Body Rear End) >> Repair Instructions >> Lock Cylinder Replacement - Endgate >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Code the new lock cylinder. Refer to Key and Lock Cylinder Coding in General Information.
    2. Fig 1: Installing Endgate Lock Cylinder
    GM1229113Courtesy of GENERAL MOTORS CORP.
  2. Install the lock cylinder to the vehicle.
  3. Press the lock cylinder into the license plate pocket until the retainers (3) are fully seated in the slots (1) of the license plate pocket.
  4. Connect the electrical connector (2) to the lock cylinder.
  5. Install the inner panel reinforcement. Refer to Reinforcement Inner Panel Replacement - Endgate .
  6. Install the inner trim panel. Refer to Trim Panel Replacement - Endgate (Envoy XUV) .
scientia non olet · About LEMON Manuals