LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1422 (Body Rear End) >> Repair Instructions >> Lock Actuator Replacement - Liftgate >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the liftgate latch assembly from the liftgate. Refer to Latch Replacement - Liftgate .
  2. Place the latch assembly on a clean, prepared surface.
    3. Fig 1: View Of Lock Actuator To Latch Assembly
    GM739852Courtesy of GENERAL MOTORS CORP.
  3. Remove the 2 screws (2) that retain the lock actuator (1) to the latch assembly.
    4. Fig 2: View Of Lock Actuator Rubber Bumper In Latch
    GM747835Courtesy of GENERAL MOTORS CORP.
  4. Simultaneously lift up on and rotate the actuator away from the latch in order to disengage the rubber bumper (1) from the latch.
scientia non olet · About LEMON Manuals