LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1422 (Body Rear End) >> Repair Instructions >> License Plate Pocket Replacement (Envoy XUV) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Swing Function Handle Connector & Main License Plate Pocket Connector
    GM1204240Courtesy of GENERAL MOTORS CORP.
  1. Install the license plate pocket to the endgate.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the nuts retaining the license plate pocket to the endgate.

    Tighten:  Tighten the license plate pocket nuts to 10 N.m (89 lb in).

  3. Connect the main license plate pocket electrical connector (1).
  4. Connect the electrical connector to the swing function handle (2).
  5. Install the license plate pocket wiring harness retainers to the endgate.
  6. Install the lock cylinder. Refer to Lock Cylinder Replacement - Endgate .
  7. Install the inner reinforcement. Refer to Reinforcement Inner Panel Replacement - Endgate .
  8. Install the endgate trim panel. Refer to Trim Panel Replacement - Endgate (Envoy XUV) .
scientia non olet · About LEMON Manuals