LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1422 (Body Rear End) >> Repair Instructions >> Hinge Filler Panel Replacement - Midgate Sliding >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the midgate inner panel. Refer to Midgate Panel Replacement - Inner .
  2. Open the midgate.
    3. Fig 1: Locating Midgate Sliding Hinge Filler Panel Retainers
    GM1236624Courtesy of GENERAL MOTORS CORP.
  3. Lift the midgate sliding hinge filler panel, slide the retaining clips (1) up to secure the sliding panel.
  4. Remove the rivets retaining the sliding panel hinge to the midgate assembly using a drill and 6.35 mm (1/4 in) drill bit.
  5. Remove the sliding hinge panel assembly from the midgate.
    Fig 2: Removing Sliding Hinge Panel Assembly From Midgate
    GM1033946Courtesy of GENERAL MOTORS CORP.
  6. Remove the loose rivets from inside the midgate assembly to prevent any rattles.
scientia non olet · About LEMON Manuals