LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1422 (Body Rear End) >> Repair Instructions >> Hinge Filler Panel Replacement - Midgate Sliding >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Sliding Hinge Panel Assembly To Midgate
    GM1033946Courtesy of GENERAL MOTORS CORP.
  1. Install the midgate sliding hinge panel to the midgate.
  2. Install the rivets retaining the midgate sliding hinge panel to the midgate assembly.
    3. Fig 2: Pressing Midgate Sliding Hinge Filler Panel Retainers Down To Release
    GM1236624Courtesy of GENERAL MOTORS CORP.
  3. Slide the clips (1) retaining the sliding hinge panel down to release the sliding hinge panel.
  4. Lower the midgate sliding hinge filler panel down onto the cargo floor.
  5. Close the midgate assembly.
  6. Install the midgate inner panel. Refer to Midgate Panel Replacement - Inner .
scientia non olet · About LEMON Manuals