LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1422 (Body Rear End) >> Repair Instructions >> Handle/Striker Replacement - Liftgate Window >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Striker Assembly Retainer Nuts
    GM856361Courtesy of GENERAL MOTORS CORP.
  1. Install the handle and striker assembly to the liftgate window.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the nuts retaining the striker assembly to the liftgate window.

    Tighten:  Tighten the nuts to 6 N.m (53 lb in).

  3. Check the liftgate window for proper operation, adjust if necessary. Refer to Striker Adjustment - Liftgate Window .
scientia non olet · About LEMON Manuals