LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1422 (Body Rear End) >> Repair Instructions >> Handle Replacement - Endgate >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Swing the endgate open.
  2. Remove the trim panel from the endgate. Refer to Trim Panel Replacement - Endgate (Envoy XUV) .
  3. Remove the rear body control module. Refer to Module Rear Body Control Replacement - Endgate .
  4. Remove the inner panel reinforcement. Refer to Reinforcement Inner Panel Replacement - Endgate .
    5. Fig 1: Disconnecting Electrical Connector From Endgate Handles
    GM1204240Courtesy of GENERAL MOTORS CORP.
  5. Disconnect the electrical connector (2) from the endgate handles.
    6. Fig 2: Removing Screws Retaining Handles To License Plate Pocket
    GM1229115Courtesy of GENERAL MOTORS CORP.
  6. Remove the screws retaining the handles to the license plate pocket.
  7. Remove the handles from the endgate.
scientia non olet · About LEMON Manuals