LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1422 (Body Rear End) >> Repair Instructions >> Bumper Replacement - Liftgate >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Liftgate Bumper
    GM721399Courtesy of GENERAL MOTORS CORP.
  1. Position the bumper assembly to the body.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the bolts that retain the bumper assembly to the body.

    Tighten:  Tighten the bolts to 25 N.m (18 lb ft).

  3. Close the liftgate.
scientia non olet · About LEMON Manuals