LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1422 (Body Rear End) >> Repair Instructions >> Actuator Replacement - Rear Quarter Window >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Disconnecting Rear Quarter Window Actuator Electrical Connector
    GM830984Courtesy of GENERAL MOTORS CORP.
  1. Remove the rear interior trim panel covering the actuator. Refer toGarnish Molding Replacement - Body Side Window - Rear (TrailBlazer EXT, Envoy XL) in Interior Trim.
  2. Disconnect the electrical connection (1).
    3. Fig 2: Removing Actuator Arm-To-Window Hinge Screw
    GM1231409Courtesy of GENERAL MOTORS CORP.
  3. Remove the actuator arm (1) to the window hinge screw (2)
  4. Remove the actuator retaining nuts.
  5. Remove the actuator from the vehicle.
    6. Fig 3: Securing Window Bracket To Window Frame
    GM1231176Courtesy of GENERAL MOTORS CORP.
  6. Using a 2.0 mm (0.08 in) pin (1), secure the window bracket (3) to the window frame (4).
scientia non olet · About LEMON Manuals