LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1419 (Body Front End) >> Repair Instructions >> Headlamp Housing Panel Replacement (TrailBlazer) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the grille. Refer to Grille Replacement (Envoy, Envoy XUV) , Grille Replacement (TrailBlazer) , Grille Replacement (Bravada) or Grille Replacement (Rainier) in Exterior Trim.
  2. Remove the headlamp assemblies. Refer to Headlamp Replacement (TrailBlazer) , Headlamp Replacement (Envoy, Envoy XUV) , Headlamp Replacement (Bravada) or Headlamp Replacement (Rainier) in Lighting Systems.
  3. Release the tabs that retain the ambient temperature sensor to the headlamp housing panel.
  4. Note the wiring harness routing for installation.
    5. Fig 1: Removing Headlamp Housing Panel-To-Core Support Bolts
    GM752279Courtesy of GENERAL MOTORS CORP.
  5. Remove the bolts that retain the headlamp housing panel to the core support.
  6. Remove the headlamp housing panel from the vehicle.
scientia non olet · About LEMON Manuals