LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1419 (Body Front End) >> Repair Instructions >> Air Inlet Grille Panel Replacement (Envoy, TrailBlazer) >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the windshield wiper arms. Refer to Wiper Arm Replacement in Wiper/Washer Systems.
    2. Fig 1: Removing Air Inlet Grille Panel (Envoy, TrailBlazer)
    GM742164Courtesy of GENERAL MOTORS CORP.
  2. Remove the air inlet grille panel retaining nuts.
  3. Remove the air inlet grill panel push-pin retainers.
  4. Disconnect the washer hose.
  5. Remove the air inlet grille panel from the vehicle, by pulling upwards in order to disengage the retaining clips.
  6. Place the air inlet grille panel on a clean, prepared surface.
  7. Remove the rear hood seal from the air inlet grille panel studs.
scientia non olet · About LEMON Manuals