LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1419 (Body Front End) >> Repair Instructions >> Air Inlet Grille Panel Replacement (Envoy, TrailBlazer) >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Installing Air Inlet Grille Panel (Envoy, TrailBlazer)
    GM742164Courtesy of GENERAL MOTORS CORP.
  1. Position the rear hood seal to the air inlet grille panel.
  2. Install the rear hood seal to the air inlet grille panel studs.
  3. Position the air inlet grille panel to the vehicle.
  4. Push downward on the air inlet grille panel to seat the retaining clips.
  5. Connect the washer hose.
  6. Install the push-pin retainers.
    7. NOTE: Refer to Fastener Notice in Cautions and Notices.
  7. Install the air inlet grille retaining nuts.

    Tighten:  Tighten the air inlet grille nuts to 4 N.m (35 lb in).

  8. Install the windshield wiper arms. Refer to Wiper Arm Replacement in Wiper/Washer Systems.
scientia non olet · About LEMON Manuals