Conditions for Setting the DTC

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

DTC B0012 (stage 2) or B0016 (stage 1) will set when the I/P module deployment loop resistance is less than 1.3 ohms for 500 milliseconds.
DTC B0013 (stage 2) or B0017 (stage 1) will set when one of the following conditions occurs:
- The I/P module high circuit is less than 2.4 volts and the I/P module deployment loop is more than 6 ohms for 500 milliseconds.
- The I/P module deployment loop resistance is more than 4.8 ohms for 500 milliseconds.
DTC B0014 (stage 2) or B0018 (stage 1) will set when one of the following conditions occur:
- The I/P module high circuits and/or low circuits is short-to-ground, or short-to-voltage for 500 milliseconds.
- The I/P module high circuit is less than 2.4 volts and I/P module deployment loop resistance is less than 6 ohms for 500 milliseconds.