LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1416 (Engine Control System - 4.8L, 5.3L, & 6.0L - Introduction) >> Repair Instructions >> Spark Plug Wire Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 Chevrolet TrailBlazer, and 2004 Buick Rainier. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Spark Plug Wire & Boot
    GM343699Courtesy of GENERAL MOTORS CORP.
  1. Remove the spark plug wire from the spark plug.
    • Twist each spark plug 1/2 turn.
    • Pull only on the boot in order to remove the wire from each spark plug.
  2. Remove the spark plug wire from the ignition coil.
    • Twist each spark plug boot 1/2 turn.
    • Pull only on the boot in order to remove the wires from the ignition coil.
scientia non olet · About LEMON Manuals