LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1416 (Engine Control System - 4.8L, 5.3L, & 6.0L - Introduction) >> Repair Instructions >> Fuel Pressure Regulator Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 Chevrolet TrailBlazer, and 2004 Buick Rainier. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Exploded View Of Fuel Rails & Injector Components
    GM350543Courtesy of GENERAL MOTORS CORP.
  1. Relieve the fuel system pressure. Refer to Fuel Pressure Relief Procedure .
  2. Disconnect the fuel pressure regulator vacuum line.
  3. Clean any dirt from the fuel pressure regulator retainer and the surrounding area.
  4. Remove the fuel pressure regulator retainer (8).
  5. Remove the fuel pressure regulator (9).
  6. Ensure non of the following parts are still in the fuel rail.
    • Backup ring (10)
    • Regulator seal O-ring (11)
    • Regulator filter (12)
    • Regulator seal O-ring (13)
scientia non olet · About LEMON Manuals