LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1416 (Engine Control System - 4.8L, 5.3L, & 6.0L - Introduction) >> Repair Instructions >> Fuel Filler Hose Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 Chevrolet TrailBlazer, and 2004 Buick Rainier. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing Fuel Fill Pipe Housing
    GM730795Courtesy of GENERAL MOTORS CORP.
  1. Remove the fuel fill cap.
  2. Remove the fuel fill pipe housing.
    3. Fig 2: Removing/Installing Fill Pipe Bracket Nuts
    GM730799Courtesy of GENERAL MOTORS CORP.
  3. Remove the fuel fill pipe bracket nut (2).
  4. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
    5. Fig 3: Removing/Installing Fuel Fill Pipe Ground Strap Bolt
    GM730802Courtesy of GENERAL MOTORS CORP.
  5. Remove the fuel fill pipe ground strap bolt (3).
    6. Fig 4: Identifying Fuel Pipe/Hose Components
    GM730806Courtesy of GENERAL MOTORS CORP.
  6. Loosen the fuel hose clamp (1).
  7. Separate the fuel hose (2) from the tank.
  8. Cap the open end of the fuel tank.
  9. Remove the push pin fastener (5).
  10. Remove the fuel filler pipe from the vehicle.
scientia non olet · About LEMON Manuals