LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1416 (Engine Control System - 4.8L, 5.3L, & 6.0L - Introduction) >> Repair Instructions >> Evaporative Emission (EVAP) Hoses/Pipes Replacement - Canister/Fuel Tank >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 Chevrolet TrailBlazer, and 2004 Buick Rainier. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating EVAP Components
    GM887437Courtesy of GENERAL MOTORS CORP.
  1. Remove the caps from the fuel tank roll over valve and canister.
  2. Install and connect the EVAP pipe to the roll over valve (4).
  3. Install and connect the EVAP pipe to the canister (3).
  4. Install the fuel tank. Refer to Fuel Tank Replacement .
scientia non olet · About LEMON Manuals