LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1416 (Engine Control System - 4.8L, 5.3L, & 6.0L - Introduction) >> Repair Instructions >> Evaporative Emission (EVAP) Hoses/Pipes Replacement - Canister Vent >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 Chevrolet TrailBlazer, and 2004 Buick Rainier. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locating EVAP Components
    GM887437Courtesy of GENERAL MOTORS CORP.
  1. Install the EVAP canister vent pipe.
  2. Remove the caps from the EVAP vent valve and canister.
  3. Connect the EVAP canister vent pipe at the EVAP vent valve (1).
  4. Connect the EVAP canister vent pipe to the canister (3).
  5. Install the fuel tank. Refer to Fuel Tank Replacement .
scientia non olet · About LEMON Manuals