LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1416 (Engine Control System - 4.8L, 5.3L, & 6.0L - Introduction) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Vent Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 Chevrolet TrailBlazer, and 2004 Buick Rainier. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Fuel Tank & Related Components
    GM887435Courtesy of GENERAL MOTORS CORP.
  1. Install the EVAP canister vent valve onto the bracket.
  2. Inspect for proper retention of the EVAP vent valve on the bracket.
  3. Connect the EVAP vent pipe to the EVAP canister vent valve.
  4. Connect the EVAP canister vent valve electrical connector (2).
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals