LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1415 (Engine Control System - 4.2L (Introduction)) >> Repair Instructions >> Fuel Tank Replacement (TrailBlazer, Envoy, Bravada, Rainier) >> Assembly Procedure

Assembly Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Fuel Tank Components
    GM730888Courtesy of GENERAL MOTORS CORP.
  1. Install the fuel sender assembly (4) to the fuel tank. Refer to Fuel Sender Assembly Replacement .
  2. Connect the EVAP vapor pipe to the fill limiter vent valve (3) and the front and rear rollover valve (2, 5). Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
  3. Install the EVAP vent valve pipe.
  4. Connect the fuel feed and return pipes to the fuel sender (4). Refer to Quick Connect Fitting(s) Service (Plastic Collar) .
  5. Install the fuel feed and return pipes to the retaining clip (6).
  6. Install the fuel filter (7). Refer to Fuel Filter Replacement .
  7. Install the EVAP vent valve (1). Refer to Evaporative Emission (EVAP) Canister Vent Solenoid Valve Replacement .
scientia non olet · About LEMON Manuals