LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1415 (Engine Control System - 4.2L (Introduction)) >> Repair Instructions >> Evaporative Emission (EVAP) Hoses/Pipes Replacement - Engine/Chassis >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: EVAP/Fuel Hose/Pipe Assembly
    GM731899Courtesy of GENERAL MOTORS CORP.
  1. Place the new EVAP purge pipe (3) in the EVAP/fuel hose/pipe assembly.
  2. Install the EVAP/fuel hose/pipe assembly. Refer to Fuel Hose/Pipes Replacement - Filter to Engine .
scientia non olet · About LEMON Manuals