LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2002 >> Blazer 4D Utility, 4WD, Part Time >> Repair and Diagnosis >> External Pages >> Different car >> Section 1415 (Engine Control System - 4.2L (Introduction)) >> Repair Instructions >> Evaporative Emission (EVAP) Canister Vent Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing EVAP Canister Vent Valve
    GM730717Courtesy of GENERAL MOTORS CORP.
  1. Install the EVAP canister vent valve (1) on the bracket (2).
  2. Inspect for proper retention of the EVAP vent valve (1) on the bracket (2).
  3. Connect the EVAP vent pipe (3) to the EVAP canister vent valve (1).
    4. Fig 2: Locating Fuel Tank Electrical Connectors
    GM730919Courtesy of GENERAL MOTORS CORP.
  4. Connect the harness connector (2) to the EVAP canister vent valve.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals