Installation Procedure

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2004 Oldsmobile Bravada, 2004 GMC Envoy XUV, 2004 GMC Envoy XL, 2004 GMC Envoy, and 2004 Chevrolet TrailBlazer. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing EVAP Canister Retaining Bracket

Courtesy of GENERAL MOTORS CORP.

Install the EVAP retaining bracket (2) to the EVAP canister (3) ensuring the retaining bracket clip (1) is fully engaged.

Fig 2: Removing/Installing EVAP Canister From Mounting Bracket

Courtesy of GENERAL MOTORS CORP.

Install the EVAP canister (3) to the mounting bracket (2).

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the bolt (1) attaching the EVAP canister (3) to the mounting bracket (2).
Tighten: Tighten the bolt to 20 N.m (15 lb ft).

Fig 3: Removing/Installing EVAP Canister Mounting Bracket

Courtesy of GENERAL MOTORS CORP.

Install the EVAP canister and bracket assembly to the vehicle.
Install the bolts (1) to the EVAP mounting bracket (2).
Tighten: Tighten the bolts to 20 N.m (15 lb ft).

Fig 4: Disconnecting/Connecting EVAP Canister Pipes

Courtesy of GENERAL MOTORS CORP.

Connect the evaporative emission (EVAP) vapor pipe (1) to the EVAP canister.
Connect the EVAP purge pipe (2) to the EVAP canister.
Connect the EVAP vent pipe (3) to the EVAP canister.
Lower the vehicle.
Install the spare tire. Reference the owners manual for additional information if needed.